Company dynamics

Current location:HOME > Information dynamics > Company dynamics >

Operation specification and maintenance of granite platform

2022-06-14 10:57:42

Operation specification and maintenance of granite platform

the granite platform used for detection is a mechanical inspection and measurement gauge. The granite platform used for detection is adjusted and parallel on the support before use

I. purpose: this specification is formulated to protect the accuracy of measurement, reduce human errors, and confirm the consistency of measurement process

II. Scope of application: this operation specification is applicable to all granite platforms for inspection

III. granite platform calibration cycle: one year

IV. operation steps of granite platform:

1. Before measuring on the granite platform, check whether the granite platform is obviously damaged, clean, inclined, etc

2. Place the measured object gently on the granite platform for various measurements

3. Keep the granite platform clean after the test

v. daily maintenance:

1. Maintenance records of granite platform for inspection must be made every week

2. Check whether the working surface of the granite platform for inspection has dust, dirt, inclination, etc., so as to prevent the granite platform from being damaged and reduce the measurement accuracy

maintenance method of granite platform:

the installation and commissioning of granite platform is a very meticulous work. After leveling the three main fulcrums on the platform support, fine tune with the other two auxiliary fulcrums to keep the plate in a relatively horizontal state; Then wipe the working surface of the granite platform as clean as possible, and use it when it is confirmed that there is no problem. In the process of use, it is necessary to try to avoid excessive collision between the workpiece and the working surface of the flat plate, so as to prevent the damage of the working surface of the flat plate and affect the accuracy of the working surface; The weight of the workpiece should not exceed the rated load of the plate, otherwise it will reduce the working quality, cause useless deformation of the platform, and may damage the structure of the plate, so it cannot be used. When removing stains on the granite platform, remember to use neutral cleaners instead of those with bleaching properties. Also do not use hard brushes and abrasive cleaners. Like other stones, a good way to prevent granite stains is to clean up spilled liquid in time. Some owners will use various sealants to protect the granite surface, but in any case, they should reseal regularly

the maintenance method of granite platform is acid stain. It is far better to dry the stain than to wipe it off, because wiping will cause the stain to spread. Most stains such as vinegar or fruit juice can be removed with paste made of baking powder and soda water. After the paste dries and hardens, wipe it off with a wet towel and then dry it with a dry towel. Food stains. For hardened food stains, hydrogen peroxide can be used, but the time should not be too long. Once the stain disappears, wipe it with a wet cloth and then dry it. Grease stains. Use a paper towel to absorb grease, and then use an absorbent such as Taibai powder to sprinkle it on the stain area. Leave for 1 to 2 hours. Then wipe it with a wet rag and dry it. Nail polish stains. Drop a few drops of dishwashing liquid in about half a liter of warm water and wipe it with a clean white cloth. Do not leave any dishwashing liquid, wipe it off with another wet cloth and dry it. Repeat the cleaning until it is stained. Doing a good job in the daily maintenance of granite platform is a basic quality that every platform user should have, which can not only protect the productivity and efficiency, but also greatly extend the service time and life of granite platform

  • Tel:+86-13561283719


  • Contact:Manager Su

  • Address:West head of zhaozhaizi village, zhaozhaizi Town, Gaotang County

Follow website

Follow website

Copyright © 2022-2023 All Rights Reserved Gaotang Ruijing Precision Machinery Co., Ltd 鲁ICP备2022021351号-1